1993 VOLKSWAGEN JETTA 4DR SEDAN
Security
Battery RED + (+) INGITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Starter01 RED/BLK + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BRN/WHT (-) DRIVER'S KICK PANEL
TrunkTrigger BRN/BLK (-) (-) DRIVER'S KICK OR OEM ALARM BEHIND FUSEBO
HoodTrigger BRN/RED (-) (-) DRIVER'S KICK OR OEM ALARM BEHIND FUSEBO
FactoryAlarmDisarm DISARMS W/UL
ParkingLights GRY/BLK L (+) GRY/RED R AT LIGHT SWITCH
Security
Parking Lights
ALSO (+) GRAY/RED-DIODE ISOLATE
Remote Start
Battery RED + (+) INGITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Ignition02 BRN/RED + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 RED/BLK + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach BLK/RED (-) (-) AT COIL
SpeedSense WHT/BLU (AC) DRIV FIREWALL 3 WIRE PLUG FROM TRANSAXLE
ParkingLights GRY/BLK L (+) GRY/RED R AT LIGHT SWITCH
BrakeLights RED/BLK (+) (+) AT BRAKE SWITCH
Horn BLK/YEL AT 3 PIN PLUG BEHIND FUSEBOX
Doorlocks / Window
PowerUnLock RED/BLK (+) POSITIVE TRIGGER
PowerLock YEL/RED (+) DRIVER'S KICK PANEL
Convenience
HeadLights WHT/BLK (+) AT LIGHT SWITCH
TrunkRelease GRY (+) AT SWITCH IN GLOVE BOX "SEE TECH TIP"
Mobile Audio / Video
Battery RED + (+) INGITION SWITCH HARNESS
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRY/BLU (+) RADIO HARNESS
Dimmer N/A
FrontLeftSpeakerPos BLU/BLK
FrontLeftSpeakerNeg ORN/BLK
FrontRightSpeakerPos RED/WHT
FrontRightSpeakerNeg ORANGE/WHITE
RearLeftSpeakerPos RED/LT.GRN
RearLeftSpeakerNeg ORN/BLK
RearRightSpeakerPos BLU/LT.GRN
RearRightSpeakerNeg ORN/RED
Amp IF AMPED AT EACH SPK
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
